Nokia 7302 - Page 97

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Monitor Commands
Issue: 10 3HH-11982-AAAA-TQZZA 97
Sample output:
A:ALA-12>monitor>router>ospf# interface to-104 interval 5 repeat 3 absolute
============================================================================
Monitor statistics for OSPF Interface "to-104"
============================================================================
At time t = 0 sec (Base Statistics)
----------------------------------------------------------------------------
Tot Rx Packets : 8379 Tot Tx Packets : 8528
Rx Hellos : 8225 Tx Hellos : 8368
Rx DBDs : 6 Tx DBDs : 12
Rx LSRs : 2 Tx LSRs : 1
Rx LSUs : 55 Tx LSUs : 95
Rx LS Acks : 91 Tx LS Acks : 52
Retransmits : 2 Discards : 0
Bad Networks : 0 Bad Virt Links : 0
Bad Areas : 0 Bad Dest Addrs : 0
Bad Auth Types : 0 Auth Failures : 0
Bad Neighbors : 0 Bad Pkt Types : 0
Bad Lengths : 0 Bad Hello Int. : 0
Bad Dead Int. : 0 Bad Options : 0
Bad Versions : 0
----------------------------------------------------------------------------
At time t = 5 sec (Mode: Absolute)
----------------------------------------------------------------------------
Tot Rx Packets : 8379 Tot Tx Packets : 8528
Rx Hellos : 8225 Tx Hellos : 8368
Rx DBDs : 6 Tx DBDs : 12
Rx LSRs : 2 Tx LSRs : 1
Rx LSUs : 55 Tx LSUs : 95
Rx LS Acks : 91 Tx LS Acks : 52
Retransmits : 2 Discards : 0
Bad Networks : 0 Bad Virt Links : 0
Bad Areas : 0 Bad Dest Addrs : 0
Bad Auth Types : 0 Auth Failures : 0
Bad Neighbors : 0 Bad Pkt Types : 0
Bad Lengths : 0 Bad Hello Int. : 0
Bad Dead Int. : 0 Bad Options : 0
Parameters interface — Specify the interface's IP address (ip-address) or interface name (ip-int-name). Up
to 5 interfaces can be specified. If the string contains special characters (#, $, spaces, etc.),
the entire string must be enclosed within double quotes.
interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Item Description
(2 of 2)