on the same key as the present one, wait until the
cursor appears, and enter the letter.
To insert a number, press and hold the number key.
To switch between the upper and lower case mode and
the number mode, press #.
To erase a character, press the backspace key. Press and
hold the backspace key to erase more than one
character.
To access the most common punctuation marks, press
the 1 key. Press 1 repeatedly to reach the desired
punctuation mark.
To add special characters, press *. Scroll to the desired
character and press the scroll key.
To insert a space, press 0. To move the cursor to the
next line, press 0 three times.
To switch between the different character cases, press
#.
Predictive text input
1. To activate predictive text input, press # twice
quickly. This activates predictive text input for all
editors in the device. The indicator
is shown
on the display.
2. To write the desired word, press 2-9. Press each key
only once for one letter.
3. When you have finished writing the word and it is
correct, scroll right to confirm it, or press 0 to add
a space.
If the word is not correct, press * repeatedly to view
the matching words the dictionary has found.
If the ? character is shown after the word, the word
you intended to write is not in the dictionary. To
add a word to the dictionary, select Spell, enter the
word (up to 32 letters) using traditional text input,
and select OK. The word is added to the dictionary.
When the dictionary is full, the new word replaces
the oldest added word.
Write the first half of a compound word; to confirm it,
scroll right. Write the last part of the compound word.
To complete the compound word, press 0 to add a
space.
To switch predictive text input off for all editors in the
device, press # twice quickly.
Change the writing
language
When you are writing text, you can change the writing
language. For example, if you press the 6 key
repeatedly to reach a specific character, changing the
writing language gives you access to characters in a
different order.
If you are writing text using a non-Latin alphabet and
want to write Latin characters, for example e-mail or
web addresses, you may need to change the writing
language. To change the writing language, select
Options > Writing language, and a writing
language that uses Latin characters.
23
Cyan
Magenta
Yellow
Black
Cyan
Magenta
Yellow
Black
To Next Page
Loading...
Need help?
General
