Automatic redial — Set your device to make a maximum of 10 attempts to connect
the call after an unsuccessful call attempt. To stop automatic redialling, press the end
key.
Show call duration — Display the length of a call during the call.
Summary after call — Display the length of a call after the call.
Speed dialling — Activate speed dialling.
Anykey answer — Activate anykey answer.
Contact search — Activate contact search in the home screen.
Line in use — This setting (network service) is displayed only if the SIM card supports
two subscriber numbers, that is, two phone lines. Select which phone line you want to
use for making calls and sending text messages. Calls on both lines can be answered
irrespective of the selected line. If you select Line 2 and have not subscribed to this
network service, you are not able to make calls. When line 2 is selected,
is displayed
in the home screen.
Line change — Prevent line selection (network service), if supported by your SIM card.
To change this setting, you need the PIN2 code.
Network settings
Select Menu > Ctrl. panel > Settings and Phone > Network.
To select the network mode, select Network mode and Dual mode, UMTS, or GSM. In
dual mode, the device switches automatically between networks.
Tip: Selecting UMTS enables faster data transfer, but may increase the demand on
battery power and reduce the battery life. In regions close to both GSM and UMTS
networks, selecting Dual mode may cause constant jumping between the two
networks, which also increases the demand on battery power.
To select the operator, select Operator selection and Manual to select from available
networks, or Automatic to set the device to select the network automatically.
To set the device to indicate when it is used in a microcellular network (MCN), select
Cell info display > On.
Connection settings
Select Menu > Ctrl. panel > Settings and Connection.
Select from the following:
Bluetooth — Edit the Bluetooth settings.
USB — Edit the data cable settings.
Settings 167
To Next Page
Loading...
