Use EAP plug-ins
To use an EAP plug-in when you connect to a WLAN using the access point, select the
desired plug-in and Options > Enable. The EAP plug-ins enabled for use with this access
point have a check mark next to them. To not use a plug-in, select Options > Disable.
To edit the EAP plug-in settings, select Options > Edit.
To change the priority of the EAP plug-in settings, select Options > Raise priority to
attempt to use the plug-in before other plug-ins when connecting to the network with
the access point, or Options > Lower priority to use this plug-in for network
authentication after attempting to use other plug-ins.
See the device help for more information on EAP plugins.
Session initiation protocol (SIP) settings
Select Menu > Ctrl. panel > Settings and Connection > SIP settings.
The session initiation protocol (SIP) is used for creating, modifying, and terminating
certain types of communication sessions with one or more participants (network
service). Typical communication sessions are video sharing and net calls. SIP profiles
include settings for these sessions. The SIP profile used by default for a communication
session is underlined.
To create a SIP profile, select Options > New SIP profile > Use default profile or Use
existing profile.
To select the SIP profile you want to use by default for communication sessions, select
Options > Default profile.
Edit SIP profiles
Select Menu > Ctrl. panel > Settings and Connection > SIP settings.
Select Options > Edit and from the following:
Profile name — Enter a name for the SIP profile.
Service profile — Select IETF or Nokia 3GPP.
Default destination — Select the destination to use for the internet connection.
Default access point — Select the access point to use for the internet connection.
Public user name — Enter your user name provided by your service provider.
Use compression — Select if compression is used.
Registration — Select the registration mode.
Settings 175
To Next Page
Loading...
