Mounting and connecting the Nokia FastMile 4G
Receiver
76
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-AADA-TCZZA Issue: 02 DRAFT
The status LED behaves differently depending on whether the Nokia FastMile 4G Receiver
will be remotely managed from:
• the Nokia Altiplano FastMile Controller (through NETCONF): see Table 5
• an ACS (through TR-069): see Table 6
Table 5 Status LED behavior for a Nokia FastMile 4G Receiver remotely
managed from the Nokia Altiplano FastMile Controller
Table 6 Status LED behavior for a Nokia FastMile 4G Receiver remotely
managed from an ACS
20 If you installed a Compact multi-band model of the Nokia FastMile 4G Receiver, you can
check the signal strength LEDs on the Nokia FastMile 4G Receiver by pressing the
measurement button on the side of the unit. Figure 57 shows the location of the
measurement button.
LED color LED priority LED behavior Status information
Blue First priority Blinking Bluetooth connection in progress
Solid Bluetooth connection established
Off No Bluetooth connection
Red Second priority Blinking Critical alarm
Solid Major or minor alarm
Off No alarm
Green Third priority Blinking twice per second Kernel and application start up
Blinking one per second Application start up
Solid Start up
Off OAM link is established
LED color LED priority LED behavior Status information
Blue First priority Blinking Bluetooth connection in progress
Solid Bluetooth connection established
Off No Bluetooth connection
Green Second priority Blinking twice per second Kernel and application start up
Blinking one per second Application start up
Solid Start up
Off Software is stable
To Next Page
Loading...
