4
Configure the following parameters:
Table 7-29 DMZ parameters
Field Description
ALG Config Select the checkboxes to enable the protocols to be supported by the ALG: FTP, TFTP, SIP, H323,
RTSP, L2TP, IPSEC, PPTP.
DMZ Config
WAN Connection List Select a WAN connection from the list.
Enable DMZ Select this checkbox to enable DMZ on the chosen WAN connection.
DMZ IP Address Select Custom Settings and enter the DMZ IP address or select the IP address of a connected
device from the list.
5
Click Save DMZ.
END OF STEPS
7.35 Configuring access control
This procedure describes how to configure the access control level (ACL).
Note: ACL takes precedence over the firewall policy.
The trusted network object will be shared for all WAN connections; it is not applied individually
to a WAN connection.
1
Click Security→Access Control from the left pane in the GPON Home Gateway page. The
Access Control page displays.
Configure a G-2426G-A indoor ONT
Security configuration
Configuring access control
7368 ISAM ONT
Draft Draft
September 2020
Issue 1 133
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-XXXXX-AAAA-TCZZA
To Next Page
Loading...
