• Dual-band concurrent 2x2 IEEE 802.11b/g/n 2.4 GHz and 802.11ac MIMO 5 GHz
• Supports 802.11 b/g/n 2x2 Wireless 2.4 GHz MIMO; Channel bandwidth 20, 40 MHz, auto
• Supports 802.11ac 2x2 Wireless 5 GHz Mu-MIMO; Channel bandwidth 20, 40, 80 MHz, auto
• Four Gigabit standard RJ-45 10/100/1000 Mbps, auto negotiating Ethernet ports and MDI/MDIX
auto sensing
• Two POTS ports with R-J11 connectors
• Two USB 2.0 Type A ports
Note:
The POTS ports and supported USB ports varies for each specific variant. For details, see
Table
4-1, “Identification of G-2426G-A indoor ONTs” (p. 35)
for the configuration on each specific
variant.
• GPON uplink: G.984 and G.988 series standard compliant
• 256MB NAND Flash with bad block management, 512MB DDR3 RAM, pin2pin compatible
design for possible upgrade of RAM/Flash
• WLAN on/off push button
• WPS on/off push button
• LEDs on/off push button
• Reset button
• Triple-Play services, including voice, video and high speed Internet access
• Support for fax services
• Built-in layer 2 switch; Line Rate L2 traffic
• IP video distribution
• Wavelength: 1490 nm downstream; 1310 nm upstream
• Supports WBF filter.The GPON ONTs can co-exist with XGSPON ONTs in the same PON
• PHY rate: 300 Mbps for 2.4 G and 867 Mbps for 5 G
• External antennas with 5dBi gain for each
• Optics that support received signal strength indication (RSSI)
• 64/128 WEP encryption
• WPA, WPA-PSK/TKIP
• WPA2, WPA2-PSK/AES
• VLAN tagging/detagging and marking/remarking of IEEE 802.1p per Ethernet port.
• Dying gasp support
• Voice Services via Session Initiation Protocol (SIP)
• Multiple voice Code
• DTMF dialing
• Echo cancellation (G.168)
• Fax mode configuration (T.30/T.38)
• Caller ID, call waiting, call hold, 3-way calling, call transfer, message waiting
G-2426G-A unit data sheet
G-2426G-A general description
7368 ISAM ONT
Draft Draft
September 2020
Issue 1 39
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-XXXXX-AAAA-TCZZA
To Next Page
Loading...
