● Access point in use — Select which access point is used
as the preferred connection.
● Multimedia retrieval — Select how you want to receive
messages. To receive messages automatically in your
home network, select Auto in home netw.. Outside your
home network, you receive a notification that there is a
message to retrieve in the multimedia message centre. If
you select Always automatic, your device automatically
makes an active packet data connection to retrieve the
message both in and outside your home network.
● Allow anonymous msgs. — Select whether you want to
reject messages from an anonymous sender.
● Receive adverts — Select whether you want to receive
multimedia message advertisements.
● Receive reports — Select whether you want the status
of the sent message to be shown in the log (network
service).
● Deny report sending — Select whether you want to
prevent your device from sending delivery reports of
received messages.
● Message validity — Select for how long the message
centre resends your message if the first attempt fails
(network service). If the message cannot be sent within
this time period, the message is deleted from the message
centre.
E-mail settings
Manage mailboxes
Select
> Messaging and Options > Settings > E-
mail.
Select which mailbox you want to use to send and
receive e-mail — Select Mailbox in use and a mailbox.
Remove a mailbox and its messages from your
device — Select Mailboxes, go to the desired mailbox, and
select Options > Delete.
Create a new mailbox — Select Mailboxes > Options >
New mailbox. The name you give to the new mailbox
replaces Mailbox in the Messaging main view. You can have
up to six mailboxes.
Change the connection settings, user settings, retrieval
settings, and automatic retrieval settings — Select
Mailboxes and a mailbox.
Connection settings
Select
> Messaging and Options > Settings > E-
mail > Mailboxes, a mailbox, and Connection settings.
Incoming e-mail
To edit the settings for the e-mail you receive, select
Incoming e-mail and from the following:
● User name — Enter your user name given to you by your
service provider.
● Password — Enter your password. If you leave this field
blank, you are prompted for the password when you try
to connect to your remote mailbox.
● Incoming mail server — Enter the IP address or host
name of the mail server that receives your e-mail.
● Access point in use — Select an internet access point
(IAP).
● Mailbox name — Enter a name for the mailbox.
© 2009 Nokia. All rights reserved. 41
To Next Page
Loading...
