FS-13 Flash adapter
Flash adapter FS-13 is used for phone testing and flashing. FS-13 is
used with the generic flash adapter base SS-60/62 and control unit
CU-4 or interface adapter SS-46.
When flashing or system testing the phone, the adapter is attached to
replace the phone own battery.
All functions (as well as the calibration voltages, current and the
protections for over voltages, over current and voltage polarity), are
performed by CU-4.
Flash adapter FS-13 main features:
• VBATT supply interface
• USB / FBUS multiplexed interface to the phone
• Supply voltage for light source
MJ-66 Module jig
MJ-66 is meant for component level troubleshooting.
The jig includes an RF interface for GSM, WCDMA, Bluetooth and NCW
(WLAN). In addition, it has the following features:
• Provides mechanical interface with the engine module
• Provides galvanic connection to test pads
• Multiplexing between USB and FBUS media, controlled by Vusb
• UI test interface
• MMC interface
• Audio components: IHF, MIC, earpiece
• Connector for control unit
• Access for system connector
Note: In the picture, two RF probes are shown. These are not
part of the MJ-66 sales package and must be ordered
separately.
•
Table 7 Attenuation values
Band Attenuation
GSM850 0.25
GSM900 0.25
GSM1800 0.4
GSM1900 0.45
WCDMA1900 0.45
WCDMA2100 0.5
RM-91; RM-92
Nokia Customer Care Service Tools and Service Concepts
Page 4 –8 COMPANY CONFIDENTIAL Issue 1
Copyright © 2006 Nokia. All rights reserved.
To Next Page
Loading...
