● Ensure that both the sender and recipient are
registered to the UMTS network. If you invite
someone to a sharing session and the recipient’s
device is not within UMTS network coverage, does
not have video sharing installed, or person-to-
person connections set up, the recipient does not
receive invitations. You receive an error message
that indicates that the recipient cannot accept the
invitation.
Settings
To set up video sharing, you need person-to-person
and UMTS connection settings.
Person-to-person connection settings
A person-to-person connection is also known as a
Session Initiation Protocol (SIP) connection. The SIP
profile settings must be configured in your device
before you can use video sharing. Ask your service
provider for the SIP profile settings, and save them in
your device. Your service provider may send you the
settings or give you a list of the needed parameters.
To add a SIP address to a contact card:
1. Press
, and select Contacts.
2. Open the contact card (or start a new card for that
person).
3. Select Options > Add detail > Share video.
4. Enter the SIP address in the format
username@domainname (you can use an IP
address instead of a domain name).
If you do not know the SIP address for the contact,
you can use the phone number of the recipient,
including the country code, to share video (if
supported by the network service provider).
UMTS connection settings
To set up your UMTS connection:
● Contact your service provider to establish an
agreement for you to use the UMTS network.
● Ensure that your device UMTS access point
connection settings are configured properly.
Share live video or video clips
During an active voice call, select Options > Share
video:
1. To share live video during the call, select Live
video.
To share a video clip, select Recorded clip and the
clip you want to share.
You may need to convert the video clip into a
suitable format to be able to share it. If Clip must
Make calls
141
Make calls
To Next Page
Loading...
