To use the image as wallpaper in the active standby
mode, select Options > Set as wallpaper.
To set the image as a call image for a contact, select
Options > Assign to contact.
To return to the viewfinder to capture a new image,
press the capture key.
Flash
The flash is available only in the main camera.
The camera of your device has a dual LED flash for low
light conditions.
Select the desired flash mode from the active toolbar:
Automatic (
), Red-eye ( ), On ( ), and Off ( ).
Scenes
Scenes are only available in the main camera.
A scene helps you to find the right colour and lighting
settings for the current environment. The settings of
each scene have been set according to a certain style
or environment.
The default scene in the image mode is Auto, and in
the video mode Automatic (both indicated with
).
To change the scene, in the active toolbar, select Scene
modes and a scene.
To make your own scene suitable for a certain
environment, scroll to User defined, and select
Options > Change. In the user defined scene you can
adjust different lighting and colour settings. To copy
the settings of another scene, select Based on scene
mode and the desired scene. To save the changes and
return to the scenes list, press Back. To activate your
own scene, scroll to User defined, press the scroll key,
and select Select.
Capture images in a sequence
The sequence mode is available only in the main
camera.
To set the camera to capture images in sequence (if
enough memory is available), in the active toolbar,
select Sequence mode.
To start capturing images in a quick sequence,
selectBurst, and press and hold the capture key. The
device captures images until you release the key or
until the memory runs out. If you press the capture key
briefly, the device captures six image in a sequence.
To capture two or more images in defined intervals,
select the desired time interval. To capture the images,
Camera
87
Camera
To Next Page
Loading...
