Figure 19 WLAN auto tune results
FMTx2.1 troubleshooting
General
The handset uses an antenna that is integrated to the B-cover. The connection to the half loop antenna is
exposed by disassembling the phone and removing the PWB.
The half loop antenna requires two connection points, signal C-clip (X6189) and ground (PWB opening in the
another end of the FMTX antenna). It is important to check these connection points for damage or dirt since
the performance of the FMTx 2.1 implementation will be severely impaired if these connections are not in
good condition.
RX-51
BB Troubleshooting
Page 3 –64 COMPANY CONFIDENTIAL Issue 1
Copyright © 2009 Nokia. All rights reserved.
To Next Page
Loading...
