Nokia N900 Service Manual

ESD protection
Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing
the phone.
Any product of which the covers are removed must be handled with ESD protection. The SIM card can be
replaced without ESD protection if the product is otherwise ready for use.
To replace the covers ESD protection must be applied.
All electronic parts of the product are susceptible to ESD. Resistors, too, can be damaged by static electricity
discharge.
All ESD sensitive parts must be packed in metallized protective bags during shipping and handling outside
any ESD Protected Area (EPA).
Every repair action involving opening the product or handling the product components must be done under
ESD protection.
ESD protected spare part packages MUST NOT be opened/closed out of an ESD Protected Area.
For more information and local requirements about ESD protection and ESD Protected Area, contact your local
Nokia After Market Services representative.
RX-51
ESD protection
Issue 1 COMPANY CONFIDENTIAL Page v
Copyright © 2009 Nokia. All rights reserved.

Nokia N900 Specifications

General

RAM	256 MB
Internal Storage	32 GB
Operating System	Maemo 5
Battery	Removable Li-Ion 1320 mAh battery (BL-5J)
Weight	181 g
Network	GSM / HSPA
SIM	Mini-SIM
GPU	PowerVR SGX530
Memory Card slot	microSD, up to 16 GB (dedicated slot)
Loudspeaker	Yes, with stereo speakers
3.5mm jack	Yes
GPS	Yes, with A-GPS; Ovi Maps
Sensors	Accelerometer, proximity, compass
Talk time	Up to 6 h 30 min (2G) / Up to 4 h 30 min (3G)
Display	3.5 inches, 800 x 480 pixels
Processor	TI OMAP 3430
Camera	5 MP
Dimensions	110.9 x 59.8 x 18 mm
Connectivity	Wi-Fi 802.11 b/g, Bluetooth 2.1
Radio	Stereo FM radio
Browser	HTML, Adobe Flash