Nokia T-Mobile - Connecting devices for Wi-Fi or a mesh network; Connecting Ethernet LANs

T-Mobile High-Speed Internet Gateway Operator
Manual
ChapterTitleVariable
Issue: DRAFT Nokia 3TG-01275-AAAA-TCZZA 53
5.11 Connecting devices for Wi-Fi or a mesh
network
If the T-Mobile High-Speed Internet Gateway is to be used for Wi-Fi, connect devices
that are going to use Wi-Fi for service and communications through the T-Mobile
High-Speed Internet Gateway by using the SSID and Wi-Fi key shown on the
underside of the T-Mobile High-Speed Internet Gateway.
To connect a WiFI device using SSID and password, using your phone, select the
the correct Wi-Fi network name, then enter the SSID and password.
If the T-Mobile High-Speed Internet Gateway is to be used as the access point of a
Mesh Wi-Fi 6 System, see section 4.9.
5.12 Connecting Ethernet LANs
In addition to supporting the Mesh Wi-Fi 6 system on the LAN side, the T-Mobile
High-Speed Internet Gateway also supports connection of up to two Gigabit Ethernet
LAN ports.
Before connecting a Gigabit Ethernet LAN to the T-Mobile High-Speed Internet
Gateway, observe the LCD screen, which displays the CONNECTION screen. Tap
the LCD screen four times to display the DEVICES screen.
You connect a Gigabit Ethernet LAN to the T-Mobile High-Speed Internet Gateway
by connecting the cable from the Ethernet LAN to any of two Gigabit Ethernet LAN
ports on the backside of the T-Mobile High-Speed Internet Gateway.
Figure 17 shows the location of the Gigabit Ethernet LAN ports.