T-Mobile High-Speed Internet Gateway Operator
Manual
ChapterTitleVariable
Issue: DRAFT Nokia 3TG-01275-AAAA-TCZZA 65
7.6 Procedures
Procedure 8 Replacing the Battery
1 With the bottom cover removed, connect the battery connectors.
2 Place the battery right-side up in the battery cavity on the pull rib. See Figure 21.
3 Using the Phillips screwdriver (Cross), carefully replace the bottom cover and replace the
small screw to secure the bottom cover. See Figure 18.
Caution — Only use the battery with a charging system that has been qualified with the
system per CTIA Certification Requirements for Battery System Compliance to IEEE
1725. Use of an unqualified battery or charger may present a risk of fire, explosion,
leakage, or other hazard.
Caution — Promptly dispose of used batteries in accordance with local regulations
Caution — Avoid dropping the phone or battery. If the phone or battery is dropped,
especially on a hard surface, and the user suspects damage, take it to a service center
for inspection.
Caution — Improper battery use may result in a fire, explosion, or other hazard.
Note 1 — Observe the local and national laws and regulations
that may be applicable to this procedure.
Note 2 — Observe the following:
• The battery or SIM must be removed by a qualified service
personnel.
• Indoor units must be installed with cables that are suitably
rated and listed for indoor use.
• See Section 4.5 for temperature ranges of this device.
To Next Page
Loading...
