Nokia T-Mobile - Configuring system parameters

ChapterTitleVariable
86
T-Mobile High-Speed Internet Gateway Operator
Manual
Nokia 3TG-01275-AAAA-TCZZA Issue: DRAFT
12 Click Save Changes.
13 STOP. This procedure is complete.
9.8 Configuring system parameters
The following tasks can be configured using the web GUI or LCD:
• Reboot device using the web GUI or LCD (Procedure 24)
• Factory reset using the web GUI or LCD (Procedure 25)
• Firmware upgrade (Procedure 26)
• Enable debug control (Procedure 27)
Procedure 24 Rebooting the T-Mobile High-Speed Internet Gateway using the web
GUI or LCD
Follow this procedure to reboot the T-Mobile High-Speed Internet Gateway using the web GUI:
1 If you have not done so yet, complete the steps in procedure 10.
The Overview Dashboard screen appears with the web GUI menu.
2 If you have not already logged in, log into the web GUI by completing the steps in
procedure12.
3 Select System from the web GUI menu.
The System screen appears
4 Click Reboot.
The T-Mobile High-Speed Internet Gateway reboots.
5 STOP. This procedure is complete.
Follow this procedure to reboot the T-Mobile High-Speed Internet Gateway using the LCD:
Note — You will need to know the IP address of the T-Mobile
High-Speed Internet Gateway along with the user name and
password to perform these procedures. This information is
located on the label located on the bottom of the gateway.