ChapterTitleVariable
84
T-Mobile High-Speed Internet Gateway Operator
Manual
Nokia 3TG-01275-AAAA-TCZZA Issue: DRAFT
7 Click Save Changes.
8 STOP. This procedure is complete.
Procedure 22 Viewing and editing the Access Point parameters
Up to two Access Points can connect to the T-Mobile High-Speed Internet Gateway.
Use this procedure to view and edit the Access Point parameters for the T-Mobile High-Speed
Internet Gateway.
1 If you have not done so yet, complete the steps in procedure 10.
The Overview Dashboard screen appears with the web GUI menu.
2 If you have not already logged in, log into the web GUI by completing the steps in
procedure12.
3 Click Network.
Wi-Fi Networks, Access Point, and Auto Configuration Server (ACS) appear in the menu.
4 Click Access Point.
5 View the following parameters: service, authentic mode, IPv4, IPv4 Net mask, IPv6, and
MTU.
6 Click the “...” symbol on the top right corner of each Access Point.
WPA Key Enter the WPA key. TThe WPA Key has a minimum of eight
characters.
Click on the eye icon to view or
hide the WPA key.
Parameter Definition Range/Options/Example
(2 of 2)
Note — There are two Access Points pre-configured for the T-Mobile
High-Speed Internet Gateway: One for Internet and OAM traffic, one for
voice traffic (VoLTE).
• Internet and OAM traffic, which can be edited by a superadmin, but
cannot be deleted.
• Voice Traffic (VoLTE), which can be edited and deleted by the
superadmin user.
To Next Page
Loading...
