Nor-Del HD+ - Conax Smartcard Reader

27
14. TROUBLESHOOTING
Problem
Possible causes
Remedy
LED on front
panel does not
light
AC Power cord
disconnected
Connect power cord
properly into the power
socket
No picture or
sound
Wrong connection of the
Video/audio output to TV
input terminal
Wrong connection of antenna
cable
No signal or weak signal
Wrong setting of channels
Information in MENU screen
Connect two te
rminals
correctly With HDMI cable
or RCA or RF cable
Connect the antenna cable
correctly
Check the cable
connections
Type the setting value
correctly
Black
-
and
-
white
screen or V-Hold
Your TV mode is different
from broadcasting mode
Use TV of same
mode Use
the NTSC/PAL converter
Connection to the receiver
and TV
The
remote
control is not
working
Battery exhausted
Fluorescent light interfering
with the remote control
Remote control is incorrectly
aimed
Change the batteries
Switch off the light
Aim the remote control at
the receiver
Distorted menu
screen
Too high brightness and
contrast level of TV set
Adjust brightness and
contrast to low level
Not working Process down Remove the power cord