STB ---------------- #001
DVD ---------------- #001
VCR ---------------- #001
AUDIO ---------------- #001
AUX ---------------- #001
2.1 DEVICE KEY (STB, TV, DVD, VCR, AUDIO, AUX) is to chang the device.
3.1 In case of normall setting
3.1.1 Press [DEVICE + OK] keys for 1 second more. DEVICE LED will be on. Then go to setting Mode.
If code 023 is the programmed code, the LED will blink 10 times, 2 times and 3 times (Zero will be flashed 10 times).
Press [DEVICE] + [OK] KEY for over 1 second. Then LED will be on.
While the remote is in programming mode and no keys are pressed for 20 seconds.
-If press the incorrect Digit codes, the LED blinks once and on for stand by.
-If press the keys except OK, Number (0~9) up, down, info keys, LED keeps on.
4
The LED will be off and the setting mode will be cancelled.
4.1.2 Enter 3 Digit code sequently (The Device LED will blink once when press the 3 Digit codes).
-After pressing 3Digit code, the Power code data will be sent one time.
-Press the TV power key and check TV turns on.
(If TV does not turn on, check the TV Power button. Or Press other 3 digit codes.
-If press [UP] or [DOWN] key, the present setting code or next setting code of
4.2.3 power data code will be sent and LED turn on for stand by.
4.2.4 Press [OK] key and Dvice LED will blink 2 times.
4.1.3 Press [OK] key and LED will blink 2 times.
4.2
Using the Auto Search (UP, DOWN Keys)
4.2.1 Press [DEVICE] + [OK] KEY for over 1 second. Then Device LED will be on.
4.2.2 Press [UP] or [DOWN] key (LED will blink once when press [UP] or [DOWN] Keys)
HOW TO SET UP YOUR UNIVERSAL RCU
To Next Page
Loading...