35
6.4 QUICK INSTALL
The Quick Install feature of the UC4+ Spray Height Control system is
designed to help diagnose problems that cannot be identified during the
Automatic Setup. It will instantly setup the system with typical values for
valve calibration and sprayer geometry, based on the sprayer type selected.
Perform the following procedure for a Quick Install
♦ STANDARD SYSTEM (Including Passive Roll)
A1. Your system must have a minimum of two sensors.
A2. Verify the sensors are installed with the lowest serial number on
the left side increasing to the highest serial number on the right
side (Refer to the UC4+ Installation Manual).
A3. Level the boom at 35 inches height.
A4. Navigate in the SETUP menu to the "Install?" screen and
toggle "AUTO (YES)" switch.
A5. At the "Select" "Type +/-" menu prompt, select the
appropriate type for your sprayer (e.g. JD7). Sprayer types are
listed on page 54
A6. Toggle and hold "AUTO (YES)" for 5 seconds.
A7. When the word "Sensor" is displayed, release the switch. Your
system will be configured with the standard settings based on the
type you have selected and the number of sensors present.
A8. Perform a ReTune (Section 6.2).
♦ ACTIVE ROLL SYTEM
B1. Perform the Quick Install for STANDARD SYSTEM A1 to A7,
as described above.
B2. Navigate to the "Roll ?" menu prompt in the SETUP menu.
Toggle "AUTO (YES)", and then change it to "Roll OnA"
using the " +/- " switch. Toggle "AUTO (YES)" to confirm.
B3. Navigate to the "Roll ?" menu prompt in the SENSOR
DISPLAY menu. Toggle "AUTO (YES)", and then set the
"IFh" (intermediate frame height) and "BFh
" (boom frame
height) to zero using the " +/- " switch. Toggle "AUTO (YES)" to
confirm.
B4. Perform a ReTune (Section 6.2).
To Next Page
Loading...
