Norcold N4000 - Ignition and Start up; Control Panel with Touchscreen; Removing Air from the Propane Gas Supply Lines

Installation and Owner’s Manual 29
For safety reasons, the burner is made to ignite on propane gas within a specied amount of time. When starting the refrigerator for
the rst time, after storage, or after replacing propane gas tank, the propane gas supply lines can have air in them. Due to the air in the
gas supply lines, the burner may not ignite on propane gas within the specied amount of time.
To remove the air from the propane gas supply lines:
- Make sure that all of the gas valves are open.
- To turn the refrigerator on, push the on/o󰀨 switch and hold it for 1 second, as
illustrated. A light in the on/o󰀨 switch will turn green.
- Push the source button several times, as illustrated. Push until the ame appears
on the display. This means that the refrigerator is operating on propane gas.
- The refrigerator will start a 30 second trial for ignition. During the 30 second trial for
ignition, the refrigerator controls open the gas safety valve and the igniter sparks.
After 30 seconds, the refrigerator controls close the gas safety valve and the igniter
stops sparking.
- If the air in the propane gas supply lines prevents the burner from ignition on
propane gas, the fault code will appear in the center display.
- Push the on/o󰀨 switch, as illustrated, and hold it for 2 seconds to turn the refrigerator
o󰀨. All lights will go out.
- To start another trial for ignition, push the on/o󰀨 switch and hold it for 1 second to
turn the refrigerator on. A light in the on/o󰀨 switch will turn green.
- The refrigerator will start another 30 second trial for ignition. During the 30 second
trial for ignition, the refrigerator controls open the gas safety valve and the igniter
sparks. After 30 seconds, the refrigerator controls close the gas safety valve and the
igniter stops sparking.
- When the ame appears on the display and no fault code remains, this means that
the refrigerator is operating on propane gas.
Art02367
Art02352
Art02353
Before ignition or start up of the refrigerator:
- Make sure the air ow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is not
blocked or decreased.
- Make sure there are no combustible materials in or around the refrigerator.
Ignition and Start Up
Control Panel with Touchscreen
Art02366
Control panel with LCD touchscreen ........................................................................................................................................................5
On/o󰀨 switch ........................................................................................................................................................................................... 5a
Touchscreen ...........................................................................................................................................................................................5b
Mode symbols ........................................................................................................................................................................................5c
Cooling level indicators...........................................................................................................................................................................5d
Symbol ‘anti-condensation’ (only for model N4150) ...............................................................................................................................5e
Error code ................................................................................................................................................................................................ 5f
3
Art02357
Removing Air From the Propane Gas Supply Lines