Installation and Owner’s Manual 7
Selecting a source
After turning the refrigerator on, push the source button several times, as illustrated. Push
until the desired source is selected. (See Art02367)
Sources
Auto The refrigerator automatically selects the best source available
(in order: AC, DC, gas)
AC The refrigerator is powered by AC.
DC The refrigerator is powered by the battery of your vehicle.
Gas The refrigerator is powered by propane gas.
Always use the gas or AC mode to start up and cool. Operating on 12V DC is only eective while the engine of the vehicle is running.
If the ‘auto’ function on the refrigerator is selected, but no source is available, a light in the on/o switch blinks red.
The performance of the refrigerator operating on 12V DC is dependent on the thickness and length of the wiring and the overall
installation of the vehicle.
Select cooling level
After turning the refrigerator on, push the cooling level button several times, as illustrated.
Push until the desired level is selected. (See Art 02368)
We advise to set the refrigerator on cooling level 3, with an ambient temperature between
60°F and 75°F. A higher temperature needs a higher cooling level, a lower temperature a
lower level.
Turn refrigerator o
Before defrosting the refrigerator or storing your vehicle, turn the refrigerator o. Push the
on/o switch, as illustrated, and hold it for 2 seconds to turn o the refrigerator. All lights will
go out. (See Art02353)
If storing the vehicle for an extended period of time, make sure to disconnect
the fan at the rear of the refrigerator, as explained in section entitled
“Refrigerator Storage”.
NOTICE
Lowest
cooling
level
Highest
cooling
level
Art02367
Art02368
Art02353
To Next Page
Loading...
