EasyManuals Logo

Norcold N81 Series Installation Manual

Norcold N81 Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Installation Manual 10
The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 14 17/32 inches high.
- Make a lower door panel that is:
- 21 19/32 inches wide and
- 31 5/8 inches high (for N6XX models) or
- 38 5/8 inches high (for N8XX models).
- Pull the panel retainer [37] off each door (See Art00965).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.
Install Decorative Door Panels
- Make sure that the bend of the bafe is the full
width of the inside of the enclosure.
- Make sure that the bend of the bafe is ush with
the bottom edge of the upper intake vent door
frame.
- Make sure that the top edge of the bafe is 1/4
inch [213] below the bottom of the condenser
and that there is 1/4 inch or less clearance [15]
between the rear of the condenser and the bafe.
- If the depth of the enclosure is more than 26 inches
[27], install a wood or an aluminum or galvanized
steel sheet solid box bafe [21] between the lower
intake vent and the upper exhaust vent (See
Art01593).
- Make sure that the solid box bafe is the full width
of the inside of the enclosure.
- Make sure that the bottom of the solid box bafe
is 18 inches to 18 1/2 inches above the bottom of
the enclosure [17] (4 1/4 inches to 4 3/4 inches
above the top of the lower intake vent opening
REF) [18] .
- Make sure that the back of the solid box bafe is
perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box
bafe is even with the bottom edge of the upper
exhaust vent [24].
- Make sure that the vertical top edge of the bafe
is between 1/4 inch [213] below the condenser and 1 1/2 inches above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the bafe.
Art01593
27
17
10
9
18
25
21
24
1513
15
11
15
213
Art00965
37
38
39
NOTICE

Table of Contents

Other manuals for Norcold N81 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Norcold N81 Series and is the answer not in the manual?

Norcold N81 Series Specifications

General IconGeneral
BrandNorcold
ModelN81 Series
CategoryRefrigerator
LanguageEnglish

Related product manuals