Installation Manual 12
Reverse the Door Swing-Nonmetal Doors (optional)
This refrigerator has cabinet hinges that allow you to change the direction the door opens
by moving the hinges on a diagonal to the opposite side.
1. Remove the doors (See Art01726):
- Remove the storage bins from the doors.
Do not mix the upper and lower hinge pins because they are different.
- Remove and save the upper hinge pin [63] from each door.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [64] from each hinge.
2. Change the position of the cabinet hinges and the strike plate (See Art01728):
- Remove and save the screws from the strike plate [65a].
- Remove the two plastic hole caps that are near the strike plate.
- Remove the L-shaped plastic covers that are opposite the hinges.
- Remove and save the screws from the upper cabinet hinge
[66a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the lower hinge [66b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge
[67a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the upper hinge [67b].
- Attach each of these hinges with screws.
- Put the L-shaped plastic covers over the holes that were used
by the hinges.
66
Art01726
63
64
67
Art01728
66a
67a
65b
66a
66b
67a
65a
67b
67b
66b
NOTICE
To Next Page
Loading...
Need help?
General
