Installation Manual 14
Reverse the Door Swing-Metal Doors (optional)
This refrigerator has door hinges that allow you to change the direction the door opens by
moving the hinges on a diagonal to the opposite side.
1. Remove the doors (See Art00986):
- Remove the storage bins from the doors.
- Remove and save both hinge pins [71] from each door.
- Pull the door latch and remove each door away from the refrigerator.
2. Change the position of the cabinet hinges and the strike plate (See Art01728):
- Remove and save the screws from the strike plate [65a].
- Remove the two plastic hole caps that are near the strike plate.
- Remove the L-shaped plastic covers that are opposite the hinges.
- Remove and save the screws from the upper cabinet hinge [67a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the lower hinge [67b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge
[66a] of each door.
- Put each of these hinges on the other side of the refrigerator
as the upper hinge [66b].
- Attach each of these hinges with screws.
- Put the L-shaped plastic covers over the holes that were used
by the hinges.
- Remove and save the screw [41] from the front box [68] (See
Art01573).
- Pull the front box away from the refrigerator and out from
under the controls [69].
- Reverse the front box and put it on the opposite side of the
controls.
- Attach the front box to the refrigerator with the screw.
- Put the strike plate on the opposite side of the refrigerator
[65b].
- Put the two round plastic caps into the holes that are near the
strike plate.
71
73
66
67
74
Art00986
Art01728
66a
67a
65b
66a
66b
67a
65a
67b
67b
66b
To Next Page
Loading...
Need help?
General
