1. Notes
www.nord.com B1000 -5-
1.4 Safety information
All work including transportation, storage, installation, electrical connection, commissioning,
servicing, maintenance and repair must be performed only by qualified specialist personnel.
It is recommended that repairs to NORD Products are carried out by the NORD Service
department.
Danger!
Installation and maintenance work may only be performed when gear units are at a standstill.
The drive must be isolated and secured to prevent accidental start-up.
Tighten the drive elements or secure the parallel key before switching on.
Danger!
Only transport use the eyebolts attached to the gear unit. No additional loads may be
attached. Transportation aids and lifting gear must have an adequate load-bearing capacity.
If geared motors have an additional eyebolt attached to the motor, this must also be used. Avoid
pulling the eyebolts at an angle. The thread of the eyebolt must be fully screwed in.
Observe all safety information, including that provided in the individual sections of this
Operating Manual. All national and other regulations on safety and accident prevention must
also be observed.
Danger!
Serious physical and property damage may result from inappropriate installation, non-
designated use, incorrect operation, non-compliance with safety information, unauthorised
removal of housing components or safety covers and structural modifications to the gear unit.
To Next Page
Loading...
Need help?
General
