4 Commissioning
BU 0540 EN-1516 37
Basic parameters
If the current setting of the frequency inverter is not known, loading the default setting is
recommended P523 = 1. The inverter is pre-programmed for standard applications in this
configuration. If necessary, the following parameters can be adjusted with the optional SimpleBox SK
CSX-0 or ControlBox TU3-CTR.
P5--
Additional
parameter
As standard, the actual
output frequency is displayed
P102
Acceleration time
0 ... 320s
Motor data
See 4.1 Default Settings
P400
Analog input function
0...10V frequency
Operating value display
(or operational)
following mains ON
P103
Deceleration time
0 ... 320s
P104
Min. frequency
0 ... 400Hz
P105
Max. frequency
0.1 ... 400Hz
P420
Digital input function 1
- ON right -
P523
=1
Load factory data
Pos: 12 0 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par ameter/ _Par amet er -1- (Überschrift) [ SK 5xxE] @ 0\mod_1327572853172_388.docx @ 7316 @ 1 @ 1