3 Displays and control
BU 0505 EN-3021 77
3 Displays and control
As delivered, without the technology unit, 2 LEDs (green/red) are visible externally. These indicate the
actual device status.
The green LED indicates that the mains voltage is present and operational, while a flashing code that
increases in speed shows the degree of overload at the frequency inverter output.
The red LED signals actual error by flashing with a frequency which corresponds to the number code
of the fault (please see chapter 6 "Operating status messages").
Pos: 107 /Anleitungen/ Elektronik/F U und Starter/3. Anzeige, Bedi enung und Optionen/SK 5 xxE/3.1 Modulare Baugr uppen [SK 5xxE] @ 0\mod_132749 2754652_388.doc x @ 6283 @ 2 @ 1
3.1 Modular assemblies SK 5xxE
By the use of various modules for display, control and parameterisation, the SK 5xxE can be easily
adapted to a wide range of requirements.
Alphanumerical display and operating modules can be used for simple commissioning. For more
complex tasks, various connections to a PC or an automation system can be selected.
The Technology Unit (Technology Unit, SK TU1-...) is connected externally to the front of the
frequency inverter and is therefore easy to access and replace at any time.
Fig. 9: Modular assemblies SK 5xxE
Pos: 108 /Anleitungen/ Elektronik/F U und Starter/3. Anzeige, Bedi enung und Optionen/SK 5 xxE/3.2 Übersicht der Technologieboxen -1- @ 0\mod_1327492858354_3 88.docx @ 6306 @ 2555 @ 1
LED
To Next Page
Loading...
