nord NORDAC PRO SK 500E Series - Fig. 11 Top Side of FI with RJ12; RJ45 Connection; Table 32: Simplebox SK CSX-0, Functions

3 Displays and control
BU 0505 EN-3021 81
NOTICE
Parallel operation of control elements
The SimpleBox SK CSX 0 must not be used in combination with the SK TU3-POT, SK TU3-CTR, SK TU3-PAR,
the handheld control units SK …- 3H or their built-in versions SK …-3E or the Remote control window of the
NORD CON software. As all of these elements use
the same communication channel, this may cause
communication errors.
Assembly
The SimpleBox can be attached to any technology unit (SK TU3-…) or to the blind cover. To remove
it, simply pull it off after the RJ12 connection has been detached (press in the latching lever on the
RJ12 connector).
Connection
The SimpleBox is connected to the socket at the upper
edge of the frequency inverter using the RJ12
connector/cable.
The Bus termination resistor for the RS485 interface
must be set with DIP switch 1 (left).
RJ12
2 x RJ45, not with
SK 500E/505E/510E
X11
X10 X9
Fig. 11 Top side of FI with RJ12 /
RJ45 connection
Functions of the SimpleBox
7-segment LED
display
When the frequency inverter is ready for operation any initial value (P104/P113 for keyboard
operation) is indicated by a flashing display. This frequency is immediately
used on being
enabled.
During operation, the currently set operating value (selection in P001) or an error code (Section 6)
is displayed.
During parameterisation, the parameter numbers or the parameter values are shown.
LEDs
1
2
The LEDs indicate the actual operating parameter set in the operating display (P000) and
the current parameter set being parameterised. The display is in binary code.
1
2
= P1
2
1
= P2
1
2
= P3
2
1
= P4
Turn the knob to
the right
Turn the knob to the right in order to increase the parameter number or the parameter
value.
Turn the knob to
the left
Turn the knob to the left in order to reduce the parameter number or the parameter value.
Briefly press the
knob
Briefly pressing the knob = “ENTER” function in order to store a changed parameter or to
change from parameter number to parameter value.
Press the knob
for longer
If the knob is pressed for a longer period, the display changes to the next higher level, if
necessary without storing a parameter change.
Table 32: SimpleBox SK CSX-0, functions