19, Attach a Front and Rear Dip Cap (33, 34) around
a Dip Handb (10) with two M3 x 32mm Selfotapo
ping Screws (102),
Tighten a Dip Arm Knob (51) into the Dip Arm (5),
Puii the Knob out as far as it wiii go and insert the
Dip Handle (10) through a Dip Arm Bushing (35)
and into the Dip Arm, Engage the Knob into the
Dip Handle,
Repeat this step on the other side of the Dip
Arm (5}.
20, Attach an Arm Pad (21) and an Arm Pad Base
(22) to the Dip Arm (5) with two M6 x 70mm
Screws (93),
Repeat this step on the other side of the Dip
Arm (5}.
21, insert a Pad Tube (17) into the Leg Developer
(6), Slide two Leg Pads (23) onto the Pad Tube,
Slide two Leg Pads (23) onto the Seat Frame (4),
22, Attach the Curl Pad (20) to the Curl Post (9) with
two M6 x 16mm Screws (87),
23, Make sure that all parts are properly tightened
before using the weight system, The use of the
remaining parts wiii be explained in the ADJUST°
MENTS section, beginning on the following page,
19
20
21
22
10
33
21
22
\
23
51
102
_ 102
93
23
17
87
11
To Next Page
Loading...
