ADJUSTmNG THE SEAT
To adjust the height of the Seat (19), Hft the Seat
Frame (4) off of the Upright (3), Set the Seat Frame
onto a different set of posts on the Upright,
For some exercises, the Seat (19) shouUd be removed
from the weight system and stored where it wHUnot
interfere with the exercise,
ATTACHING THE CURL PAD
To use the CurUPad (20), insert the CurUPost (9) into
the Seat Frame (4), Secure the CurUPost with the
CurUKnob (52),
Store the CurUPad (20) away from the weight system
while performing exercises that do not require it,
ATTACHING THE PULLEY HOUSINGS
The Pulley Housings (54) can be attached to the
Upright (3) (leg developer position), or to the Base (1)
(squat position or preacher curl position),
To attach a Pulley Housing (54), slide the hook on the
Pulley Housing onto the bracket at the desired posi-
tion, Attach the Housing CaMe (71) to the Eyehook
(65) with a CHp (61),
ATTACHING THE LEG DEVELOPER
To use the Leg Devebper (6), first move the press
arms to the bwered position (see ADJUSTING THE
PRESS ARM on page 12), Then, attach the pulley
housings to the bg devebper position (see ATTACH°
UNGTHE PULLEY HOUSINGS above), Then, attach
the Housing Cables (71) to the Leg Developer using a
Clip (61),
Curl
/
Leg
Developer
I
Squat
13
To Next Page
Loading...
