Pressthe89mmRoundCap(39)intotheUpright
(3),
insertfourMIOx55mmCarriageBolts(83)up
throughtheBase(1),Note:Coveringthebolt
headswith a pieceof tapemayheJphold
themin pJace.AttachtheUpright(3)to theBase
withthefourBoltsandfourMIONylonLocknuts
(108),Donottightenthe Locknuts.
Note:Thepartsin steps7,13,and14may
comepreassembled,if the Press Arm Cable
(not shown} is preattached, make sure that it
goes over the Dip Arm (5) as this step is com-
pleted.
Apply grease to an MIO x 115mm Bolt (84),
Attach the Dip Arm (5) to the Upright (3) with the
Bolt and an MIO Nylon Locknut (108), Make sure
that the Bolt is inserted through the indicated
hole in the Dip Arm. Do not overtighten the
Locknut; the Dip Arm must be able to pivot
easily.
Attach the Dip Arm Pin (53) to the Dip Arm (5)
with an M4 x 13mm Self-tapping Screw (112),
insert the Pin into the Dip Arm and the Upright (3),
39---_
108
/Hole
5
108
53
2
Grease
6
To Next Page
Loading...
