9
7
7. The Console (9) can use four D batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
e
xposed to cold temperatures, allow it to
warm to room temperature before inserting
b
atteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the screw, remove the battery
cover, insert the batteries into the battery com-
partments, and reattach the battery cover. Make
sure to orient the batteries as shown by the
diagrams inside the battery compartments.
To purchase an optional AC adapter, contact
the store where you purchased this product
or call the telephone number on the cover of
this manual. To avoid damaging the console,
use only a manufacturer-supplied AC
adapter. Plug one end of the AC adapter into
the jack on the console; plug the other end into
an outlet installed in accordance with all local
codes and ordinances.
Battery
C
over
Batteries
Screw
9
8
8. While another person holds the Console (9)
near the Upright (6), connect the console wire
harness to the Upper Wire Harness (55). Then,
connect the console pulse wires to the Pulse
Wires (54, 67).
Insert the excess wire downward into the
Upright (6).
Tip: Avoid pinching the wires. Attach the
Console (9) to the Upright (6) with four M4 x
16mm Screws (58).
9
54, 67
58
6
Console
Pulse Wires
Avoid pinching
the wires
55
Console Wire
Harness
To Next Page
Loading...
