NordicTrack C5ZL - Page 9

9
7
7. Orient the Upright (4) assembly and the Pivot
Cover (12) as shown.
S
lide the Pivot Cover (12) upward to the
Handlebar (5). Tip: Bend and flex the Pivot
C
over slightly to slide it over the Handlebar.
Attach the Pivot Cover (12) to the Handlebar (5)
with four M4 x 16mm Screws (90).
Pivot the Handlebar (5) until the hole in the
Handlebar is aligned with an adjustment hole in
the Upright (4).
Tighten an Adjustment Knob (27) into the
Handlebar (5) and an adjustment hole in the
Upright (4). Make sure that the Adjustment
Knob is engaged in one of the adjustment
holes.
4
12
90
90
90
27
Hole
Adjustment
Holes
5