NordicTrack COMMERCIAL VR - Backrest and Seat Handlebar Assembly

7
Q
Q7' Tip: Loosen the four M6 x 38mm Screws (25)
if the Backrest Tubes (52) do not slide into
the Seat Carriage (41).
' 821"#/'/0"'R%-D#"1/'A)+"1'GWOH'$2/4'/0"'!"%/'
@%##$%="'GUYH7'
' B//%-0'"%-0'R%-D#"1/'A)+"'GWOH'F$/0'%2'Nc'
^'QW**'R4&/'GdOH;'%2'Nc'!3&$/'.%10"#'GbQH;'
%2<'%2'Nc'M4-D2)/'Gb[H7'Make sure that the
Locknuts are in the hexagonal holes in the
Seat Carriage. Do not tighten the Bolts yet.
dO
WO
WO
OW
OW
UY
bQ
bQ
b[
b[
U7 Tip: Avoid damaging the wires inside the
Seat Handlebar (11) during this step.
' B//%-0'/0"'!"%/'V%2<&"+%#'GYYH'/4'/0"'!"%/'
@%##$%="'GUYH'F$/0'/F4'Nc'^'Xc**'R4&/1'Gd[H;'
/F4'Nc'@)#5"<'.%10"#1'GcXH;'%2<'/F4'Nc'
M4-D2)/1'Gb[H7 Make sure that the Locknuts
are in the hexagonal holes in the Seat
Carriage.'
' A0"2;'3&)='/0"'3)&1"'F$#"'GBH'$2/4'/0"'#"-"3/%-&"'
$2'/0"'?$=0/'!0$"&<'GYUH7
' See step 3. Tighten the two M8 x 35mm
Bolts (72).
U
YY
d[
cX
UY
b[
B
YU
b[