AssemMy requires two persons. PHaceaHHparts of the eHHpticaHexerciser in a cHeared area and remove the
packing matedaHs, Do not dispose of the packing matedaHs until assembHy is compHeted, In addition to the two
included he× keys, assembJy requires a phillips screwdriver C_ _, two adjustable
wrenches __ a rubber mattet r I_, and pliers
, ........ } ,
Use the drawings bellow to identify the smaHHparts used for assembHy, The number in parenthesis bellow each
drawing is the key number of the part, from the PART LHSTon page 25, The number foHHowingthe key number is
the quantity needed for assembHy, Note: Some small parts may have been pre-assembted. If a part is not in
the parts bag, check to see if it has been pre-assembled.
M4 Star M8 SpHit
Washer Washer
(16)-6 (101)-12
M8 Washer
(94)-6
Wave Washer
(100)-2
\
M8 x 25mm
Washer (95)-2
y S\
\
M8 x 28mm
Washer (99)-4
M8 Nylon
M4 x 12mm Round
Head Screw (104)-2
M4 x 25mm
Screw (105)-8
M8 x 20mm Button
Screw (113)-2
M8 x 25mm
Button BoHt(81)-2
M8 x 56mm Button Screw (108)-4 M8 x 68mm Button Screw (110)-8
M8 x 23mm FHat
Head Screw (88)-6
M8 x 76mm Button BoHt(112)-4
Remove the Pivot Arms (not shown) and the pHastic
inserts from the Left and Right Uprights (4, 3), Hdentify
the Left Upright (4) and hoHdit near the Frame (1),
WhiNeanother person Hiltsthe Heftside of the eHHipticaH
exerciser, connect the Extension Wire Harness (76) to
the Lower Wire Harness (77),
Hnsertthe Left Upright (4) into the Frame (1), and
attach it with two M8 x 56mm Button Screws (108),
two M8 x 68mm Button Screws (110), and four M8
Split Washers (101); make sure not to pinch the
Wire Harnesses (76, 77). Tighten a Frame Cushion
(32) into the Frame (1) as indicated,
While another person lifts the right side of the Frame
(1), attach the Right Upright (not shown) to the Frame
in the same way, (You do not need to connect wire
harnesses on the right side,) Tighten the other Frame
Cushion (32) into the other side of the Frame (1),
101
110
Plastic
32
Do not pinch the
wire harnesses
during this step.
32
3
To Next Page
Loading...
