10
7
8
37
38
30
31
98
9
7
7
6
44
58
13
43
97
10
9. Slide an M12 Washer (38) onto an M10 x 80mm
Shoulder Bolt (37).
While a second person holds the front end of the
Right Pedal Arm (8) inside the bracket on the
right Upper Body Leg (7), insert the M10 x 80mm
Shoulder Bolt (37) through both parts.
Then, tighten an M10 Locknut (31) with an
M10 Bright Washer (30) onto the end of the
M10 x 80mm Shoulder Bolt (37).
Repeat this step to attach the Left Pedal Arm
(98) to the left Upper Body Leg (not shown).
10. Identify the Right Upper Body Arm (6), orient it
as shown, and slide it onto the right Upper Body
Leg (7).
Attach the Right Upper Body Arm (6) with
two M8 x 45mm Carriage Bolts (44), two M8
Small Curved Washers (43), and two M8
Locknuts (13).
Repeat this step for the Left Upper Body
Arm (97).
See assembly step 5. Tighten the two M8
Locknuts (13) and the two M8 x 16mm Screws
(53). Then, press the Lower Upright Cover (58)
into place.
To Next Page
Loading...
