9
7
26
59
25
34
49
98
8
12
33
8
7. Identify the Right Pedal (34) and the Right Pedal
Arm (8), and orient them as shown.
Attach the Right Pedal (34) to the Right Pedal
Arm (8) with three M8 x 45mm Screws (33) and
three M8 Washers (12); start all the Screws,
and then tighten them.
Attach the Left Pedal (49) to the Left Pedal
Arm (98) in the same way.
8. Slide a Wave Washer (21) onto the axle on the
right Crank Arm (20).
Attach the Pedal Arm Bracket (23) on the Right
Pedal Arm (8) to the right Crank Arm (20) with an
M10 x 20mm Screw (26), an M10 Split Washer
(25), an M10 Washer (59), and a D-washer (24).
Attach the Left Pedal Arm (98) to the left
Crank Arm (not shown) in the same way.
24
23
8
21
20
98
To Next Page
Loading...
