10
STEP 7
Connect the Upper Computer Cable ( 96) and
two hand pulse cable with the cable on the
back of computer (1).Sit the Computer (1) into
its bracket and secure in place using the four
screws. Attach the Tablet Holder (98) to the
computer (1) with four screws (97): start all the
screws, and then tighten them.
STEP 8
Secure plastic cover onto the handlebar post
with a screw(4)
Note:Before using the machine, make sure all
the screws are fasten tightly
Now your machine is ready for use.
4
3
9
To Next Page
Loading...
