EasyManuals Logo

NordicTrack Spacesaver SE7i User Manual

NordicTrack Spacesaver SE7i
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
23
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and
properly tighten all parts each time the elliptical is
used. Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If a replacement power adapter is needed, see
the cover of this manual. IMPORTANT: To avoid
damaging the console, use only a manufacturer-
supplied regulated power adapter.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the side or the back of
the console. Using a bent paper clip, press and hold
the reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug and then plug in the
power adapter. Once the console turns on, check for
firmware updates (see HOW TO CHANGE CONSOLE
SETTINGS on page 21). Note: It may take a few
minutes for the console to be ready for use.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, remove the
four M4 x 16mm
Screws (not shown)
from the Large
Storage Foot (27),
and then remove
the Large Storage
Foot. Then, remove
the two M4 x 16mm
Screws (not shown)
from the Top Shield
(37), and then use a
standard screwdriver to pry the Top Shield upward off
the elliptical.
Next, look into the access opening and locate the
Reed Switch (58). Rotate the Pulley (66) until a
Magnet (41) is aligned with the Reed Switch.
A
37
27
58
41
66
MAINTENANCE AND TROUBLESHOOTING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NordicTrack Spacesaver SE7i and is the answer not in the manual?

NordicTrack Spacesaver SE7i Specifications

General IconGeneral
TypeElliptical
Resistance Levels22
Stride Length18 inches
Weight Capacity325 lbs
FoldableYes
iFit CompatibilityYes
Incline TypeManual
DisplayBacklit LCD
Dimensions80 inches L x 32 inches W x 67 inches H
Flywheel Weight13 lbs
Heart Rate MonitoringEKG Grip Pulse

Related product manuals