NordicTrack VR25 - Console to the Main Wire (43) and the Frame

10
7
2
57
8
69
7
B
B
A
A
7. Orient the Upright Cover (57) as shown. Hold the
Upright Cover near the Upright (2), and insert
the wire tie (A) and the wires (B) upward through
the Upright Cover.
Then, slide the Upright Cover (57) onto the
Upright (2).
8. Orient the Handlebar (7) as shown. While a
second person holds the Handlebar near the
Upright (2), insert the wire tie (A) and the wires
(B) upward through the Handlebar.
Tip: Avoid pinching the wires. Attach the
Handlebar (7) to the Upright (2) with two
M8 x 22mm Screws (69).
2
Avoid pinching
the wires
9
4
7
42
43
9. Untie and discard the wire tie on the Main Wire
(43) and the Frame Pulse Wires (42).
While a second person holds the Console (4)
near the Handlebar (7), connect the wires on the
Console to the Main Wire (43) and the Frame
Pulse Wires (42).
Insert the excess wire into the Handlebar (7).
Tip: It may be helpful to insert the connectors
on the wires one at a time through the hole in
the Handlebar.