Nordson 3500V Series - Page 150

Operation
A 4-13
7.
Check the Material
Safety
Data
Sheet
(MSDS)
for
the
recommended
operating temperature
of the new
adhesive.
lf
the temperature is
different from the
old adhesive, reprogram
your
unit's temperature
settings. Refer
to Table A 4-6.
Table
A 4-6 Temperature
Programming Procedures
The unit is ready
for routine
operation. Refer to
Operating
Proceduresin
this section.
Type
of Temperature
Setting Programming Procedure
Overtemperatu re
setpoint Refer to
Programming
SYSTEM
SEF/NGS
Controlsinthe
lnstallation
section of this manual.
SETPOINT or
STANDBY
temperature
setpoint
Refer to Programming
T E M P E R
AT U R E Co ntro I s in lhe
lnstallation section
of this manual
@000 Nordson
Corporalion
All riqhls reseNed
41-3000v
lssued
5/00
A4EN-06-[3V-A-AAXVI-1