Nordson 3500V Series - Page 45

A 1-6
Safety
Danger of Burns
Contact with
hot melt materials
or hot
areas
of
the unit may
produce
a
severe
skin burn.
WARNING:
Hot! Risk
of burns.
Wear
heat-protective
clothing,
safety
goggles,
and/or heat-protective
gloves
depending on the
symbols shown.
Be extremely
carefulwhen
using hot melt material. Even
solidified
material
may
still be
very
hot.
Always
wear
protective
clothing which safely
covers all exposed
parts
of
the
body.
ln
case of burns:
.
lmmediately
cool
affected skin
areas
using cold,
clean
water
.
Do not
forcefully remove
hot melt materialfrom
the skin.
.
lmmediately
seek medical
attention.
Allow only
qualified personnelto
perform
the
procedures
described
in this
document. When
performing
such
tasks,
wear
protective
clothing,
and
equipment.
WARNING:
Even when
the circuit breaker or main
power
switch is
OFF, the unit is
still electrically energized.
Complete
the following steps
prior
to maintenance or repair:
Disconnect,
lock out, and
tag external
power
supply
To ensure
the external
power
supply is disconnected,
attempt to
operate the
unit. lf the unit does
not energize,
proceed
with
maintenance
or repair work.'
lf the unit energizes,
repeat the
disconnect, lock out, and tag
procedure.
Re-test
the unit.
a
a
7.
Maintenance/Repair
a
a
AI EN{2-[XX-SAFEI-1
lssued 11/94
@
'1994
Nordson Corporation
All rights reserved