Operation
4-17
Part 1032059B
E 2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
To adjust the set-point temperature using the global-by-component
method
1. Press and hold the Hose or Gun key for three seconds.
The left display indicates the number of the first sequential hose or
gun. The right display indicates the current set-point temperature of the
hose or the gun.
2. Scroll the left display to 0.
The right display indicates all dashes (----).
3. Press a right-display scroll key.
The right display flashes.
4. Use the right-display scroll keys to enter the set-point temperature
recommended by the manufacturer of the hot melt. Refer to the
technical data sheet provided by the manufacturer of the hot melt to
determine the optimal set-point temperature.
5. Press the left-display scroll key.
The hoses or the guns begin to heat or cool to their new
set-point temperature.
To Next Page
Loading...
