Description
A 2-1
Part 331235C
E 2003 Nordson Corporation
Part A: System Overview
Section A 2
Description
Introduction
The Sure Coat modular gun control system provides pneumatic and
electrostatic controls for up to 16 Sure Coat, Versa-Spray, or Tribomatic
automatic powder spray guns. The electrostatic functions of the guns can
be controlled simultaneously by the central control unit. Each gun has an
individual pneumatic controller.
System Components
Refer to Table A 2-1 and see Figure A 2-1 for an overview of the modular
gun control system’s major components.
NOTE: Your system may not have all of the equipment listed. Refer to the
Parts section in this part of the manual for ordering information.
Table A 2-1 System Components
Item Component Description
1 Application/Triggering
Controller (Optional)
Automates triggering for all guns in the system. Refer to
Optional Equipment in this section for more information.
2 Central Control Unit Provides electrostatic controls, dc power, grouping, triggering,
and monitoring functions for all guns in the system.
3 Pneumatic Modules Control the flow rate and atomizing air to the guns. Each gun
is controlled by an individual pneumatic module.
4 Main Control Cabinet Provides electrical connections for all guns and solenoids in
the system. Houses the system power supply and driver
cards for all guns and optional equipment.
5 Main Pneumatic Section Distributes air pressure to pneumatic modules and purge
modules.
NS Gun Purge Module
(Optional)
Purges the guns’ powder paths. The gun purge module is
located in the main pneumatic section (5).
To Next Page
Loading...
