To Next PageTo Next Page
Need help?Do you have a question about the Nordson LA 404 and is the answer not in the manual?
General| Brand | Nordson |
|---|---|
| Model | LA 404 |
| Category | Control Systems |
| Language | English |
Defines warning and caution symbols used in the manual.
Guidelines for safe installation of the equipment.
Procedures for safe operation of the equipment.
Safe procedures for maintenance and repair.
Steps for safely shutting down the equipment.
Steps to safely disconnect power from the system.
Procedures to safely disable the guns.
First aid procedures for contact with molten hot melt.
Describes the LA 404 Pattern Control System's functionality.
Lists the key features and capabilities of the pattern controller.
Outlines operating, non-operating, physical, and power supply specs.
Details the performance characteristics of the pattern controller.
Describes the controls and indicators on the front panel.
Identifies the input/output connectors on the rear panel.
Provides pinout details for various I/O connectors.
Explains the connection and function of the remote input plug.
Guide for initial setup using administrator mode.
Displays and explains production metrics like speed and work rate.
Menu to activate channels and assign trigger inputs.
Configures masking, jam detect, and jam distance for each trigger.
Sets up the two-point linear pressure profile for each runup.
Ensures accurate bead placement by adjusting for gun open/close times.
Allows selection of different bead types like Normal, Modulate, etc.
Configures continuous bead output based on line speed.
Describes modulated bead patterns for consistent volume.
Configures stitched bead patterns for adhesive conservation.
Explains autospot bead pattern for residual pressure relief.
Allows mixing products of different lengths with continuous beads.
Configures dot bead patterns with specific time and spacing.
Menu to save, recall, and copy programs and channel settings.
Explains how the controller monitors and displays warning conditions.
Configures spike time and hold voltage for gun drivers.
Configures encoder type and scaling ratio for line position tracking.
Sets minimum line speed for dispensing and stopping.
Configures autostart, trigger memory, and remote recall.
Configures remote enable and trigger clipping functions.
Configures the operation of the tip sealer output.
Accesses daily operation screens like production data and triggers.
Flowchart to diagnose and resolve basic pattern controller problems.
Ratio of encoder shaft rotation to line travel.
Compensates for delay in gun response time.
Lists screen messages and explanations for engine warnings.
