LA 404 Pattern Control System
46
Part 1037527B
! 2005 Nordson Corporation
Manual 66-LA404-MA-01
Warnings
The pattern controller monitors warning conditions like:
Trigger 1 – 4 too short (clipping), T1 – 4 max distance exceeded (jamming),
Ch1 – 4 short circuit, etc.
A blinking CHANNEL LED on the front panel of the pattern controller notifies
the user that there is a fault or a warning condition, see Warnings in
Appendix A.
Press the % or & button on the front panel of the patten controller, to review
all the warnings and faults in the system.
C=5<;<JK
6640024A
Fault Condition
A fault condition occurs typically when there is a hardware or software
defect. When a fault condition occurs, the user will need to take immediate
action.
Warning Condition
A warning condition alerts the user that there may be an error with the setup
of the pattern controller. When a warning condition occurs, immediate
action may not be required.
To Next Page
Loading...
