Nordson LA 404 - Programs (1 - 50)

LA 404 Pattern Control System
45
Part 1037527B
! 2005 Nordson Corporation
Manual 66-LA404-MA-01
Programs (1 – 50)
This setup menu screen can be used to save and recall any of the 50
programs, as well as copy one channel to another.
456!5=A!@1
+=I?!=K!!!!!!!@1 !
!!!!!!!!#6
,?9=FF!!!!!!!!@@!!!!!!!!!#6
G6>S!GV1!!!!:6!!!GV1!!!!!#6
6640023A
1. To save a program:
a. Press the % or & button for the cursor to appear beside the program
number.
b. Press the " or # button to select the desired program from 01 – 50.
c. Press the % or & button for the cursor to appear beside No.
d. Press the " or # button to change No to Yes, and this will save or
recall the desired program.
2. To recall a program:
a. Press the % or & button for the cursor to appear beside the program
number.
b. Press the " or # button to select the desired program from 01 – 50.
c. Press the % or & button for the cursor to appear beside No.
d. Press the " or # button to change No to Yes, and this will save or
recall the desired program.
3. To copy a channel to another channel:
a. Press the CHANNEL SELECT button on the front panel of the patten
controller to select a channel number (Copy CH1 – 4) whose
settings you would like to copy to another channel number.
b. Press the % or & button for the cursor to appear beside CH1.
c. Press the " or # button to go from CH2 – CH4.
d. Press the % or & button for the cursor to appear beside No.
e. Press the " or # button to change No to Yes, and this will copy the
channel settings.
NOTE: The copy CH1 feature copies the channel data and setup
parameters (like delay, duration, bead type, and trigger assignment) from
the source channel to the destination channel.