LA 404 Pattern Control System
57
Part 1037527B
! 2005 Nordson Corporation
Manual 66-LA404-MA-01
Normal Mode
Use the Normal mode for daily operation of the pattern controller. In this
mode only the following screens can be accessed:
$ Production Data
$ Trigger Assignment
$ Trigger Settings
$ Pressure 1 and 2 Settings
$ Channel Compensation
$ Bead Type
$ Program
$ Warnings
Refer to the Quick Programming Guide for the sequence of menu screens
that are used to program the pattern controller.
1. Turn on the power switch located at the rear panel of the pattern
controller.
2. The pattern controller will perform a brief initializing procedure that
includes a self-diagnostic and preparation program.
The words Initializing, along with the panel and engine software versions
appear on the setup menu screen. Initializing takes between 10 – 15
seconds to complete.
"#"$"%&"'"#(
6640034A
./0/1!!!!!!!!!!!!!!!!./023
3. Press the SET UP button to access each setup screen.
NOTE: The system can be powered down at any time and all
information will be saved.
To Next Page
Loading...
