LA 404 Pattern Control System
28
Part 1037527B
! 2005 Nordson Corporation
Manual 66-LA404-MA-01
Trigger Settings (1 – 4)
After activating Triggers’ 1 – 4 in Trigger Assignment, use this menu to set
the masking distance, jam detect option, and jam distance for each trigger.
Masking is a length used to lockout the photosensors for a predetermined
distance. This distance is programmed when the products contain holes or
cutouts.
Jam detection activates a warning and output when a photosensor is active
longer than the user defined product length.
$5;JJ?5!1!+?::;<JK
L=A!)?:?9:!!!!!!!!!!!-MM!
!
L=A!);K:=<9?!! ! ! !!!!!@!AA
*=KD;<J!!!!!!! ! ! !!!!@!AA
6640011A
1. To set masking:
a. Press the % or & button for the cursor to appear beside the numeric
value.
b. Press the " or # button to select value from 0 – 9999 mm.
2. To set jam detect:
a. Press the % or & button for the cursor to appear beside Off or On.
b. Press the " or # button to On or Off. If set to On, go to step 3 to
set the jam distance.
3. To set jam distance:
a. Press the % or & button for the cursor to appear beside the numeric
value.
b. Press the " or # button to select value from 0 – 9999 mm. Enter a
value greater than the product length being glued.
To Next Page
Loading...
